Discovering The Truth About Repairs

Camden Plumbing 2017: When Do You Need to Replace Your Water Heater Reguar maintenance is an important aspect of extending the life of your water heater, and problems, like leaking or not heating up, can be managed by repair or replacement. Allow us to share some troubleshooting tips to have a long-lasting water heater because as simple as replacing a heating element or pressure-relief valve can help resolve water heater problems. There are simple water heater repairs that can be done DIY but if you are not comfortable working with your water heater, you can always call a professional like Camden Plumbing Consultant. The average life expectancy of a water heater is eight to twelve years. Camden Plumbing Consultants highly recommend replacement of water heater if it is working erratically, more than ten years old, with leaks around the base of the tank, or if it suddenly stops working. One of the most common problems of water heaters is not getting the expected heat or hotness that might be caused by a defective heating element, or a faulty thermostat. It is essential to make sure that your electric water heater is maintained properly, ensuring that the power is connected, resetting the thermostat as needed, flushing the heater to eliminate sediments from the tank, replacing thermostat and heating element, and raising thermostat temperature. When it comes to gas water heater management, you have to replace the Thermo coupler and clean the burner, ensure that the pilot is lit and the gas is connected, remove sediment by flushing, insulate hot water pipes, and raise the temperature setting on the thermostat. You have to drain your tank until the sediment clear to prevent sizzling or hissing noises coming out from your water heater. Elements must be removed and soaked in a pan filled with white vinegar for an hour and then scrape off the collected scale. Replacement of leaking pressure-relieve valve must be done. Tighten fittings of leaking water supply pipes and if does not work, you have to replace the fittings. It is essential to drain your water heater at least twice a year to remove sediments that cause corrosion and to increase efficiency. One way to test the pressure-relief valve is lifting the handle of the valve and allowing it t snap back, that should release a burst of water, otherwise, a new valve should be installed. When replacing your water heater, you need to consider the following features: gallon capacity (40 50 5 liters), recovery rate (number of gallons heated in an hour), dimensions and energy efficiency ratings. Allow us to help you with your plumbing and water heater replacement needs, feel free to check our website or homepage.Getting Down To Basics with Plumbing

Getting Down To Basics with Plumbing